#XSCOPE INTERFACE CANNOT OPEN DEVICE SOFTWARE#

T1.binĬisco IOS Software, C3900 Software (C3900-UNIVERSALK9-M), Version 15.1(3)T1, RELEASE SOFTWARE (fc2)Ĭopyright (c) 1986-2011 by Cisco Systems, Inc.Ĭompiled Sun 27-Mar-11 10:13 by prod_rel_team RTR_3925#sh run | inc bootīoot-start-marker boot system flash:c3900-universalk9-mz. See below - the command entered to set the boot uses flash:, but when it boots that is changed to flash0. As the router is running ios, the flash: keyword just goes to the first flash drive available. Under rommon, you may need to reference flash0: or flash1: instead of just flash. Any ideas? Also, I have tried old and new IOS images with the same result. If I put the 128MB flash card back in it boots right up. I tried all 6 flash cards I purchased and the all do the same thing. Please check your internal/external flash drives for the correct IOS imageĪnd issue 'reset' at the rommon> prompt to re-try the boot process. Main memory is configured to 72/72(dimm 0/1) bit mode with ECC enabledĮntering rommon> prompt after several failed attempts to boot an IOS image. Total memory size = 1024 MB - DIMM0 = 512 MB, DIMM1 = 512 MBĬ3825 platform with 1048576 Kbytes of main memory System Bootstrap, Version 12.4(13r)T11, RELEASE SOFTWARE (fc1)Ĭopyright (c) 2008 by cisco Systems, Inc. System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)Ĭopyright (c) 2006 by cisco Systems, Inc. When I reboot the router with the the new flash card I get the following error:īoot: cannot determine first executable file name on device 'flash:' I put the flash card in the router, formatted flash, and used tftp to copy over an IOS. I purchased 6 new flash cards that are all 512MB. This card is to small and I need to upgrade. There are a million guides, most of which don't even work so I think a lot of that is outdated.Īnyway I tried setting MTU size on interfaces and the internal interface but that didn't help.I have a cisco 3825 router with a 128MB flash card. Virsh start fed32srv: error: Failed to start domain fed32srvĮrror: Cannot get interface MTU on 'ovs-bridge': No such device When I start the guest it comes back with the following: The network is visible when I edit the guest in virt-manager. Ovs-int-p1 ovs-interface connected ovs-int-p1 Ovs-bridge ovs-bridge connected ovs-bridge Ovs-int-p0 ovs-interface connected ovs-int-p0 Virbr0 bridge connected (externally) virbr0 Nmcli dev show: DEVICE TYPE STATE CONNECTION For the life of me I cannot get this to work. Next step is I need kvm guests to plug into a vswitch port, with or without vlan tagging. Everything works, I created a port with vlan tagging and a new interface gets an ip address from my dhcp server in that vlan. I created ports and interfaces, and plugged in eno1. I have created an open vswitch called ovs-bridge with nmcli. None of the solutions I found seem to work and since I've been at it for days, I decided to give up and ask for help.

Xscope interface cannot open device